WATERDRIP™ ADDON KIT
User Instructions

Thank you for buying this Inland product. The WaterDrip™ AddOn Kit works with any of the SwapTop™ machines or the TwinSpin™ Disc Grinder, allowing you to feed coolant to the working area when using diamond coated blades or discs.

Safety

• It is extremely important to wear proper eye protection when using any saw or grinder. We highly recommend you wear safety goggles rather than safety glasses.
• DO NOT wear loose clothing or any accessories (long necklaces, bracelets, shirts with long fringes, and similar) that might get caught by the machine during operation.
• Use only in a properly grounded and tested outlet. NEVER override the grounding system or modify the plug.
• Set up your machine on a sturdy, level work surface that is water tolerant and at a comfortable height to work on.

Parts

The WaterDrip™ AddOn Kit includes the following parts. Make sure you have all pieces before beginning assembly.

 Set-Up

1. Insert the legs of the wire coolant reservoir stand into the two mounting brackets found on the back of the machine body.
2. Attach one end of the plastic tubing to the stem on the underside of the reservoir. NOTE: Soaking the tubing in warm water makes it easier to insert onto the stem.
3. Feed the other end through the tunnel behind the coolant flow adjustment screw.
4. Screw the nylon thumb screw (coolant flow adjustment screw) into the brass threading on the front. Turn until it just holds in place.
5. Slide the reservoir onto the loop at the top of the coolant reservoir stand.
6. Attach the free end of the coolant hose onto the nipple on the coolant feed housing of the machine. For SwapTop saws the coolant feed housing is located on the blade cover. On the TwinSpin the coolant feed housing is located on the disc cover.

Use

1. Turn the coolant flow adjustment screw on the reservoir clockwise just enough to close off the line and then fill the reservoir with plain water or plain water with a capful of Inland Diamond Coolant (stock no. 50011).
2. Make sure you have proper eye protection on and then turn on your machine.
3. Adjust the flow of coolant by slowly turning the coolant flow adjustment screw counter-clockwise. The coolant flow rate should be just enough to keep the blade or disc wet while operating. Water should not flow excessively. Increase the water flow rate ONLY if a dry powder begins to form on the tip of the material being worked.
4. Shut off the coolant flow after use. Frequently check the reservoir level and fill as needed.

Service

Questions about your machine can be answered by calling Inland Customer Service at 1-800-521-8428 Monday through Friday, 9:00 am to 5:00 PM EST, by visiting the Inland web site at www.inlandcraft.com, or emailing customer service at helpdesk@inlandcraft.com or write us at:

	Inland Craft Products, Co. 32052 Edward Madison Heights, MI 48071	Document No. 80865008 Rev No. 1
If you don't see the navigation bar at the top of your screen, click on the above logo.		Return to User Guide Index